There are two kinds of connections that a microphone Microphones by taking the cable and microphone without wires or Wireles . A microphone that will be discussed this time is a microphone cable . there was some damage / complaints are often found in these types of microphones including :
- No sound at all or totally dead.
- Sometimes flame sometimes die , lights up when the cord digerak movement or bent .
- When being held noisy sound like the voice of a rat coming out of the speaker / speaker
Before starting to improve it is good we first prepare supporting equipment , namely :
- Phillips screwdriver small size
- AVO meter
- Lead
- Alligator pliers / pliers monyong .
- Cutter knife .
- solder
This type of damage and how to fix it
NO SOUND ON / OFF TOTAL
The causes can vary from winding mik break, breaking the connecting cable connector into the mic until the cable winding miknya dropouts , therefore memperbaikinyapun must be sorted one persatu.mulailah with :
- Unplugging the microphone from the cord, then replace it with another mic cable is still good,
- When the mic is not working (not out sound from the loudspeakers) means miknya damaged
- To fix try to open mic connector that is in the mic stem by loosening the small screw that is on the outside of the mic
- Then slowly pull the connector, be careful when removing the connector cable is very short because, when you are in a hurry then the cord will break.
- Check cables from the start connector to the coil / spool is well connected, if still connected to both the next step is
- Measuring connectors 1 and 2 use AVO meter RX1,
- When the AVO meter needle does not move the coil / mic broke spull replace with new ones.
- When the mic works fine means the cord is damaged.
- To fix the microphone cable from the jack mic check, mic cable, to jack 1/4 "may be among the three components that are broken. To measure the cable try using AVO meter RX1, when the needle AVO meter mic cord broke the silence and when the needle AVO meter moves to zero and silent then the cable is still in good condition.
SOMETIMES SOMETIMES IS ILLUMINATED OFF ( ILLUMINATE WHEN OR cord moved about bent )
Usually these symptoms are due to a failure mic cables or connectors but the distance both ends of the severed close therefore the mic sometimes flame sometimes die when moved. how to fix it follow the steps in point 1. Special to the mic cord damage ( break) on the part of the cable which lights up when the cable bebengkokkan life , peel and discard the cord is decided.
MIC is being held OUT WHEN NOISY SOUND SOUND LIKE RATS OF SOUND hARDENER
Complaints like this are very common , due to the disruption of input / positive ( the line was flowing at the end of the fourth janck " , the center of the mic cable , pin / socket or connector terminal no.2 mic ) . To fix it follow the steps in point 1 .
Tidak ada komentar:
Posting Komentar